Danfoss Heating - Page 1

Datasheet Electronic Solar Heat Regulator SH-E01 Application The regulator is used for utility water management in solar heating systems. The solar heat circuit circulation pump is controlled on the basis of the differential temperature between the solar collector and the hot-water tank. If the differential temperature is higher than the preset start-up temperature differential, the circulation pump will be in operation. The pump will run until the temperature differential is 2°C. Functions The regulator is simple to install and easy to operate for the end-user: • Electrical connections on wall plate • Installer settings on regulator back • Pump exercise Product Regulator including 2 temperature sensors Regulator excluding temperature sensors Pack of 2 temperature sensors Accessories Sensor pocker, brass Sensor pocker, brass Heat-conductive paste, aluminium Heat-conductive paste, aluminium • • • • • User settings on regulator front Design suitable for use in any room Fault indication in display Forced cooling in case of overtemperature 24-hour backup in case of power failure Ordering Type SH-E01 - Code Number 088H2001 088H2000 088H2050 length 112 mm length 182 mm 8g 800 g 993N3568 993N3569 041E0110 041E0111 Data - Electronic Regulator Supply voltage Power consumption Switching action Pump output Alarm output Connections Enclosure Ambient temperature Transport temperature Min. operating value Control pollution situation Ball pressure T Rated impulse voltage Software classification Dimensions, H x W x D Weight Temperature display Approvals 230 V AC ±10% 25-42 mA Type 1B 230 V AC, max. 2(1)A 230 V AC, max. 2(1)A 2 x NTC sensor, pump, external alarm IP40 0 to 45 °C -20 to 60 °C 0.5 °C/minute Pollution degree 2 75 °C 2.5 KV Class A 90 x 135 x 26 mm 215 g T1, solar collector: -9 to 150 °C. T2, tank bottom: 0 to 99 °C EN60730-2-9, LVD, 2006/95/EC, EN60730-1, DTI type approval obtained, EMC 2004/108/EC Part No. 502v03 03/10 1

Page 2